DEPARTMENT
OF ELECTRICAL &
ELECTRONICS ENGINEERING
LIST
OF EXPERIMENTS
7EE
1203 ELECTRICAL MACHINES
LABORATORY – I
1. Open circuit and load
characteristics of D.C separately and self excited shunt
generator
-
Load
characteristics of D.C. compound generator with differential and cumulative
connection
-
Load
characteristics of D.C. shunt and compound motor
-
Load
characteristics of D.C series motor
-
Swinburne’s
test and speed control of D.C shunt motor
-
Hopkinson’s
test on D.C motor – generator set
-
Load
test on single-phase transformer and three phase transformer connections
-
Open
circuit and short circuit tests on single phase transformer
-
Sumpner’s
test on transformers
-
Separation
of no-load losses in single phase transformer
EE
1304 ELECTRICAL MACHINES LABORATORY – II
1.
Regulation of three phase alternator by emf and mmf methods
2.
Regulation of three phase alternator by ZPF and ASA methods
3.
Regulation of three phase salient pole alternator by slip test
4.
Measurements of negative sequence and zero sequence impedance of alternators.
5.
V and Inverted V curves of Three Phase Synchronous Motor.
6.
Load test on three-phase induction motor.
7.
No load and blocked rotor test on three-phase induction motor.
8.
Separation of No-load losses of three-phase induction motor.
9.
Load test on single-phase induction motor
10.
No load and blocked rotor test on
single-phase induction motor.
IC 1252
CONTROL SYSTEMS LABORATORY
List
of Experiments
1.
Determination of transfer function parameters of a DC servo motor.
2.
Determination of transfer function parameters of AC servo motor.
3.
Analog simulation of type-0 and type-1 system.
4. Digital simulation of
linear systems.
5. Digital simulation of
non-linear systems.
6.
Design and implementation of compensators.
7.
Design of P, PI and PID controllers.
8.
Stability analysis of linear systems.
9.
Closed loop control system.
10.Study
of synchros.
EE 1303
POWER ELECTRONICS LABORATORY
1.
Characteristics of SCR
2.
Characteristics of TRIAC
3.
Characteristics of MOSFET and IGBT
4.
Transient characteristics of SCR and MOSFET
5. AC to
DC fully controlled converter
6. AC to
DC half-controlled converter
7. Step
down and step up MOSFET based choppers
8. IGBT
based single-phase PWM inverter
9. IGBT
based three-phase PWM inverter
10.Resonant
dc-to-dc converter
EI 1362
MEASUREMENTS AND INSTRUMENTATION LABORATORY
1. Study
of displacement transducers
2. AC
bridges.
3. DC
bridges.
4.
Instrumentation amplifiers.
5. A/D and
D/A converters.
6. Study
of transients.
7.
Calibration of single-phase energy meter.
8.
Measurement of three phase power and power factor.
9.
Measurement of iron loss.
EE
1404 POWER SYSTEM SIMULATION
LABORATORY
1.
Computation of Parameters and Modelling of Transmission Lines
2.
ormation of Bus Admittance and Impedance Matrices and Solution
of Networks.
3.
Load Flow Analysis - I : Solution of Load Flow And Related Problems Using
Gauss-Seidel Method
4.
Load Flow Analysis - II: Solution
of Load Flow and Related Problems Using
Newton-Raphson and Fast-Decoupled Methods
5.
Fault Analysis
6. Transient and Small Signal Stability
Analysis: Single-Machine Infinite Bus
System
7.
Transient Stability Analysis of Multimachine Power Systems
8.
Electromagnetic Transients in Power Systems
9. Load – Frequency
Dynamics of Single- Area and Two-Area Power Systems
10.
Economic Dispatch in Power Systems.